https://ogma.newcastle.edu.au/vital/access/ /manager/Index ${session.getAttribute("locale")} 5 https://ogma.newcastle.edu.au/vital/access/ /manager/Repository/uon:35266 Wed 24 May 2023 12:22:28 AEST ]]> https://ogma.newcastle.edu.au/vital/access/ /manager/Repository/uon:36686 61 -butyric acid methyl ester, P3HT:[6,6]-phenyl-C₇₁ -butyric acid methyl ester, and P3HT:indene-C₆₀ bisadduct. We show that the relative contribution of light harvesting and photocurrent generation by the fullerene component is greater than that previously considered and can rise to as high as 30% of the total photocurrent generated by the binary blend system.]]> Wed 24 Jun 2020 10:04:42 AEST ]]> https://ogma.newcastle.edu.au/vital/access/ /manager/Repository/uon:37228 Tue 08 Sep 2020 11:20:17 AEST ]]> https://ogma.newcastle.edu.au/vital/access/ /manager/Repository/uon:28254 −2. The aluminum penetration into the P3HT:PCBM film was found to be consistent with the depth of this oxide layer, suggesting that aluminum penetration into the organic film is not the primary reason for performance limitations in sputtered devices. Introduction of thermally evaporated aluminum buffer layers prior to deposition of sputtered aluminum cathodes demonstrated that the performance of devices after annealing matched those of reference devices prepared with no sputtering for a buffer layer thickness of only 20 nm. Further analysis of the device J--V curves revealed an S-shaped kink prior to annealing, indicating that the major reason for the poor performance in sputtered devices was the introduction of a charge extraction barrier at the cathode, which was subsequently removed upon annealing. Rigorous removal of oxygen from the sputtering chamber prior to aluminum deposition onto the P3HT:PCBM active layer was subsequently observed to produce a device with an efficiency close to that of the thermally evaporated reference device without the requirement for evaporated buffer layers. The results presented here highlight a pathway towards an alternative R2R cathode fabrication technique that allows the highly efficient aluminum cathodes employed in small-scale devices to be transferred onto large-scale, flexible, and low-cost R2R printed organic electronic devices.]]> Sat 24 Mar 2018 07:28:36 AEDT ]]> https://ogma.newcastle.edu.au/vital/access/ /manager/Repository/uon:41684 Mon 29 Jan 2024 17:43:13 AEDT ]]> https://ogma.newcastle.edu.au/vital/access/ /manager/Repository/uon:42295 Fri 19 Aug 2022 14:58:40 AEST ]]> https://ogma.newcastle.edu.au/vital/access/ /manager/Repository/uon:34115 Fri 10 Nov 2023 15:43:35 AEDT ]]>